Nobody likes to clean the bathroom. But by taking care of it, this job will become less troublesome. Read this article for efficient instructions to keep surfaces, walls, floors, showers, and toilets in your bathroom sparkling clean.
Step
Part 1 of 3: Preparing to Clean the Bathroom
Step 1. Get rid of all the objects that shouldn't be in the bathroom
Remove all objects that shouldn't be in the bathroom such as clothes, glasses, and trash. Also take out a small table or movable storage cupboard, so you can clean the floor and walls underneath.
Step 2. Pour bleach or disinfectant into the toilet
Insert the toilet brush into the toilet, to help remove germs when brushing the thiolet.
- Make sure the floor is open and the ventilation fan is turned on to ensure proper air circulation.
- As an eco-friendly alternative, mix one tablespoon of baking soda in 1 liter of a 75/25 white vinegar and water mixture.
Step 3. Clean the dust
Generally, when cleaning any space, start from the top to the bottom. Clean the cobwebs in the corners of the bathroom and brush the dust and dirt on the floor, then sweep. A vacuum cleaner is fine to use, but you can also use a broom.
If the bathroom has a soft wallpaper installed, wrap the bristles of the brush in bathroom tissue and dampen the walls with a little water, then brush
Step 4. Apply scouring powder to the dirty areas
If water stains have accumulated in the tub, sink, or around the faucet, moisten the areas with a small amount of water and sprinkle with a scouring powder such as Comet brand. Let it sit for 10-15 minutes while you work on other work to allow the water stains to peel off and make it easier for you to scrub off.
Make sure you read the scouring powder label so you know you're using the right product and not damaging the bathroom surface. Try this product on an invisible area before using it
Part 2 of 3: Cleaning the Surface
Step 1. Clean the bathroom walls, windows, and/or ceiling
If there is mildew on the ceiling, spray a solution of water and bleach/antibacterial on the surface and let it sit for a few minutes. Do the same for the walls (if the walls are ceramic tiles) or use another cleaning product. Scrub the surface of the ceramic tile that has been sprayed with a clean sponge or cloth. Rinse carefully so that no smudges remain and dry with a clean cloth.
When scrubbing, it's best to wear rubber gloves to prevent your hands from drying out when they come into contact with harsh chemical products
Step 2. Clean the shower
Spray the cleaning product on the shower wall and shower head. Leave it for a few minutes. A special spray cleaner for removing soapy foam stains is especially good for bathroom tubs that haven't been cleaned in a long time.
- Cleaners specialized for removing water stains may be needed to clean areas prone to greenish and water-tanned stains. Do not use harsh cleaners, green abrasive sponges, or steel sponges for use on porcelain tiles as they may fade the color.
- Soak the shower head. If the shower head is clogged with water stains or soap suds, you can remove the shower head and soak it overnight in a solution of white vinegar and water, then brush with an unused toothbrush.
-
Scrub the walls around the shower, faucet and shower head. Rinse with hot water and/or dry with a towel. You can wipe the faucet with a tissue or a towel to make it shiny.
-
Don't forget the curtains in the shower. This part is also susceptible to fungus. A solution consisting of 2/3 water and 1/3 bleach in a spray bottle is useful for removing mildew stains. You can also lower the curtains and wash them in hot water mixed with a little soap and bleach.
Step 3. Clean the sink and the surface around the sink
Scrub the soap suds and toothpaste spills with a small amount of cleaning liquid, rinse by wiping them with a sponge. An unused toothbrush or cotton balls can be useful for removing dirt between the faucet and the handle.
- Never clean the sink and surfaces around the sink with the same rag or tissue you use to clean the toilet, as this can spread germs. To prevent this, you can use a special cloth only to clean the toilet.
- Clean the fronts and tops of cabinets and drawers. You will need to use hot, soapy water to clean it. If you are concerned about germs on these surfaces, add a little bleach to the soap solution.
Step 4. Clean the mirror
Use a cleaner, rinse, and scrub off excess water with a towel or squeegee (a cleaning tool with rubber blades). To make the mirror shine, add a little vinegar to the water.
Step 5. Clean the outside of the toilet
Wipe the outside of the toilet with a rag soaked in an antiseptic liquid, starting at the handle of the flush so as not to contaminate the flush handle again. Clean and rinse all exterior surfaces of the toilet including the bottom and sides, top and bottom of the seat and seat cover, with a rag and detergent or similar cleaner.
Don't forget to use a special cloth to clean the toilet or toilet paper (discard it immediately after use, but don't throw it into the toilet)
Step 6. Scrub the toilet with a special toilet brush and flush
You don't have to scrub hard: let the soapy water and patience do the work. Apply a concentrated acid cleaner, which is usually sold in a bent-neck bottle, to the inside of the toilet. Pay special attention to affixing the entire inner edge of the toilet lip. The liquid will spread to other parts.
Let the cleaning liquid sit for half an hour or so before scrubbing all parts of the toilet including the bottom lip of the toilet with a special toilet brush. Let the cleaning liquid sit a little longer after you've applied it all over the toilet, even if you've scrubbed a little bit first, then scrub it a few more times and flush
Step 7. Sweep and mop the bathroom floor
Start at the corner at the door. Sweep all the dust and dirt from cleaning parts of the bathroom and let it fall on the floor, then mop using a solution of soapy water and bleach. Remember, rinse the floor with clean water to remove any slippery soap residue. Also make sure to clean the sides of the toilet that are connected to the floor. This part is very dirty. Don't forget to clean the bottom edge of the bathroom because there is usually a lot of dust.
Step 8. Get an unused toothbrush and scrub the floor
Get rid of the remaining toothpaste on the floor. Apply a small amount of bleach or a cleaning product that is safe to use on a toothbrush to clean the sink surface. Then rub it! Toothbrushes can be used in tight areas or where very detailed scrubbing is required.
Part 3 of 3: Keeping the Bathroom Clean
Step 1. Turn on the ventilation fan
Keeping the air circulating in the bathroom will prevent the growth of mildew. The task of cleaning the bathroom was not done too often. Turn on the ventilation fan after using the shower to dry the bathroom and prevent moisture.
Step 2. Dry the shower after use
To ensure mold and mildew does not develop in the shower, dry the shower after each use. Moreover, if coupled with turning on the ventilation fan, it will make the bathroom free of moss.
Step 3. Keep the bathroom tidy
What we call “mess” is a mess. If clothes are scattered in the bathroom, place a basket or cardboard box in the bathroom as a container for dirty clothes. Use a toothbrush holder or glass to keep your toothbrush neat. Store other equipment in the unused shoe box under the sink to keep the sink surface tidy.
Step 4. Use a toilet brush
Even if they don't look dirty, the minerals in the water can stain the toilet. Regularly brushing the toilet with a strong toilet brush is a good move. Even if you only do it once a week, cleaning the bathroom will be much easier and less frequent.
Step 5. Remove toothpaste stains
Toothpaste stains that accumulate on the sink and mirror will make the bathroom look dirtier. Make sure you clean and rinse the sink after brushing your teeth, then dry it.
To sum up this work, do it while you're gargling with mouthwash for additional benefits for the teeth
Tips
- Rinse the sponge or scrubbing brush when cleaning the bathroom and change the mop if it gets dirty. The purpose of cleaning the bathroom is to get rid of dirt and dirty water, not spread it into the bathroom.
- Many nooks and crannies can't be cleaned with a sponge or rag. Cotton balls can be used like toothbrushes (use them only for cleaning bathrooms!) to clean hard-to-reach corners or between tiles.
- Remember: moss's number one enemy is bleach. Applying a small amount of bleach will remove mold stains without scrubbing.
- A cleaner to remove stains because water can also be sprayed on the shower head to remove clogs caused by water stains and restore water flow. For best results, spray the cleanser several times a week after using the shower.
- You can remove stains from evaporation of water on the mirror by using regular shaving cream. Dab cream on the mirror, then rub. There must be no scratch marks on the mirror. The results are amazing!
- Don't forget to clean the ceiling. A solution of water and bleach in a spray bottle can also be used to remove mildew on ceilings.
- After the tub has been cleaned according to the instructions above, you can use a no-rinse bath and shower cleaner (the Tilex Company manufactures this product in the United States) that is applied after bathing, to keep the bath or shower clean so you don't have to worry about cleaning it too much.
- Squeegee will make the glass surface look very clean without water stains.
- Scrub between the tiles with bleach to reveal the layer.
Warning
- Do not mix bleach with ammonia! Even sponges that have previously been in contact with bleach can react with ammonia and produce toxic chlorine gas.
- Read the label on the cleaning product to determine whether it can be mixed with bleach or not. Products like Windex usually contain ammonia. Use the product with caution if you have previously used bleach.
