Hoarding swimming pools can cause various problems that we do not expect. Once empty, the pool may float above the ground. In fact, when the soil is under certain conditions, ponds can actually float out of the ground and this can cause erosion or cause problems for the foundations of nearby houses. Below is an easy and inexpensive way to stockpile a swimming pool.
Step
Step 1. Dry the pool
Do this when the soil is dry so the pool doesn't float out of the ground. If the water contains chlorine or other hazardous chemicals, be sure not to dump it into ditches or other places that can cause environmental damage.
Step 2. Use a concrete crusher, hammer crusher, or other tool to drill holes in the bottom of the pool
This hole can be used as a drain.
Step 3. Remove pool curbs, poolside tiles, and any other concrete around the pool that you no longer want
Dump into the pool through the holes you have made.
Step 4. Fill the pond cement with a layer of crushed stone or split stone
Add a layer of sand on top or fill it completely with soil. If possible, compact it as you fill it so that the soil doesn't sink too much later. If you want to plant something on it, don't forget to use good quality soil as high as 30 cm for the top layer.
Tips
- Placing a filter cloth over the opening in the bottom of the pool will prevent clogging and allow water to drain properly.
- These instructions do not apply to vinyl, fiberglass, and metal swimming pools. Instructions only apply to concrete swimming pools.
Warning
- If you put in a lot of concrete and don't use crushed stone and sand, the surface of the former pool will settle down more.
- Check your local ordinances and Local Building Regulations (PBS) to find out what you are allowed to stockpile in the ground. You may be prohibited from stockpiling vinyl or concrete.
- Make sure you make lots of holes (or break the bottom of the hole) to allow the pool water to drain properly.