A beautiful green lawn, a bed of beautiful flowers or a variety of fresh vegetables in the garden are the result of hard work and a willingness to dedicate time, effort and money to achieve the final result. The process of making this mind, body and soul conditioning facility can be made easier by installing your own irrigation system.
Step
Method 1 of 2: Types of Irrigation Systems
Step 1. Determine the type of irrigation system that suits your needs
The types of irrigation systems that are often used are drip, bubble and spray. Each system performs better in a given situation. You must determine whether one or a combination of several systems is right for you to install
- Drip irrigation systems use low water pressure with no air spray to properly water the plants. This system is made of a perforated water hose or pipe that is laid or buried just below the ground surface and is connected to the controller. This system is perfect for flower beds or gardens.
- Bubble irrigation systems use moderate water pressure so that instead of spraying the sprinkler head, it “bubbles” the water and slowly moistens the soil. This arrangement is mounted on a small water line connected to a controller, or a valve that can be activated as needed. This irrigation system is intended to irrigate deep soil and is usually used to water bushes and trees.
- Spray irrigation systems spray water with a compressed air spray that uses a zone system to irrigate flowerbeds and gardens along with lawns. Usually it is this sprayer that causes water to run through roads and sewage systems, because the water that is splashed is not able to be fully accommodated by the soil.
Method 2 of 2: Installation of an Irrigation System
Step 1. Connect to the water source, then install the channel and water sprinkler head as needed
You can use an outside faucet that can be attached to a hose as a water source. You will need to find a water source to do more complicated ties
Step 2. Find the best locations to install your system and spray head
Mark the location with spray watercolor.
- If the drip system is used, the channel can be installed just below the surface or above the ground. You will need to dig a little soil or make a trench for the installation of drains. Simply place a drain over a flowerbed or garden. Protect the channel on the ground of the saplings.
- The installation of a bubble or spray system requires a trench as the location of the drain for the spray heads.
- Start the conduit with PVC tubing and tees at the spray head location. Use glue and sleeve as adhesive. Cut the channel with a pipe saw or large scissors.
- Installation of the sprayer head and cutting of the extension tee can be carried out after the irrigation canal and the extension tee have been completed. Use PVC glue.
Step 3. Backfill your excavation and slowly turn on the faucet to perform a pressure test on the system
Gradually increase the pressure on the line. The spray head should be working.
Step 4. Adjust the spray head for maximum coverage and check for leaks
Make repairs to the drain if you see water seeping from the ground.
Tips
- Install the valve at the lowest point of the system to drain the line and prevent water from freezing in it and damaging the line.
- You will most likely have to use a domestic water source to your home. Ask a licensed plumber to install faucets and backflow preventers. The rest you can do yourself.
- Cover the sprinkler hose or drip irrigation canal at ground level with a cloth covered in pine or spruce mulch. The shield will keep the soil moist and prevent excess water. The mulch will protect the PVC pipeline from the sun.
- Familiarize yourself with DIY shops in your city as they are great places to ask questions.
