E6000 is a versatile glue used for industry. Its strength, flexibility and adhesion make it the primary glue for craft, jewelry, household and repair products. However, it is important to apply it with care, as this glue is difficult to remove and contains toxic chemicals. The solvents used to remove E6000 glue also contain harsh or toxic solvents.
Step
Method 1 of 3: Removing E6000 From Skin
Step 1. Act immediately if the E6000 starts to harden on the skin
This glue can cause irritation.
Step 2. Wash the skin with an orange Goo Gone solvent or similar
Look for an exfoliating scrub if liquid alone doesn't work.
Step 3. Soak a tissue in naphtha spirit or acetone nail polish remover, then rub it into the skin for a few minutes
Try scrubbing again with Goo Gone's glue remover.
Be careful because skin that is in prolonged contact with naphtha or acetone can also be irritated
Step 4. Wash the skin with soap and water
rinse.
Method 2 of 3: Remove Craft Glue E6000
Step 1. Isolate the part you want to dip into the solvent remover
Place it on a pile of newspapers in a ventilated area.
Step 2. Wear rubber gloves and protect the rest of the skin with thick clothing
Step 3. Apply a small amount of acetone nail polish remover or spirit naphtha to the area
E6000 hardens as the solvent evaporates, so adding solvent back to the glue loosens it.
If you're worried that the chemical will crack things, test it on a small area first before you remove the glue
Step 4. Leave the solvent for 10 to 30 minutes
Do not inhale chemicals. Check again and test if the glue has gone.
Apply more acetone or WD-40 if the solvent has dripped off the item. Use less gasoline if the object is hard and resistant to this solvent
Step 5. Wash the item with dishwashing detergent and water
Repeat as necessary.
Method 3 of 3: Removing Industrial Glue E6000
Step 1. Separate the item you want to use solvent for whenever possible
For example, to remove the E6000 from a car part, remove that part of the car so you don't splash solvent on other parts.
Step 2. Wear rubber gloves, a ventilation face mask, and do this on a non-combustible surface, such as concrete
You should also remove the E6000 in a ventilated area.
Step 3. Pour gasoline into the bucket
Soak the object in the bucket for 10 to 30 minutes. You can also use Chevron 1000 oil-based products.
Be careful when putting objects in the bucket. Spilled gasoline can pose a fire risk
Step 4. Keep coals or flames away from the object as the glue melts
Step 5. Take the object out and try to pry it out
If the glue is still sticking, soak it again for another 30 minutes to an hour and then try again.
Step 6. Rinse the item with mineral spirits or another cleaning product
Dispose of water, oil and spirits with hazardous materials. Do not throw into sewers or waterways.
Tips
- Dry cleaning solvents can also remove E6000. Most of these chemicals are prohibited for personal use, because they produce CFC substances that damage the ozone layer.
- Try cutting or prying off the glue in the area with a utility knife (cutter) if the object cannot be dipped in solvent.