Do you want to make a flamethrower to impress your friends? Are you very bored? The flamethrower is very easy to build and requires only simple tools (at least for the more dangerous basic versions). Read the steps below to make 3 types of flamethrowers with different levels. Some of them may be more difficult to make than others. Let's get serious a little bit: This thing very dangerous. Using them, fire can re-enter the canister and detonate the fuel canister, causing you serious injury or death. Know that everything is at your own risk. Please don't blame us if something untoward happens.
Step
Method 1 of 3: Using a Lighter (small flame)
Step 1. Prepare a lighter
You can buy it at most small shops.
Step 2. Remove the cover
The cover can be pulled or removed vigorously, but you can also use pliers.
Step 3. Adjust the wheel
Slide the adjustment wheel towards the plus sign (usually to the right).
Step 4. Swipe back to the left
Lift the tube up so it touches the wheel and then slide the tube all the way to the left.
Step 5. Place and repeat
You can do this several times to change its position as much as possible.
Step 6. Turn on the lighter
Be careful. You will get 3 times bigger fire. You can reset the lighter if needed.
Step 7. Make the fire bigger
Make the fire bigger by spraying WD-40 or engine oil cleaner on the fire. He will make the fire VERY BIG.
Method 2 of 3: Using a Can (medium heat)
Step 1. Put the rubber band
Place two rubber bands around the aerosol can.
You can use an Ax can, hairspray, or whatever
Step 2. Place the bracket
Place a wall bracket (which should be bent at a 90-degree angle) under the rubber band so that it holds the can in such a way.
Step 3. Make the adhesive
Take a small piece of plastic and place it on the bottom of the candle.
Alternatively, you can use chewing gum
Step 4. Attach it to the bracket
Attach the candle to the wall bracket using plastic or other adhesive.
Step 5. Arrange as necessary
Align the wick of the candle with the nozzle of the aerosol can.
Step 6. Light the candle
Be careful.
Step 7. Spray
Do not spray it in a flammable area. Be careful.
Method 3 of 3: Using Water Gun/Super Soaker (big fire)
Step 1. Provide a high quality water gun
The water gun must be able to create and withstand pressure well, it is best to buy one that uses high-quality plastic material, and can hold a lot of liquid.
Step 2. Provide a metal bracket
You need metal brackets, while the use of brackets that are flat or like the letter L depends on the shape of the water gun you have. Attach the bracket to the gun, so that the flat metal part is parallel to the ground, about 3 cm below the gun mouth.
Step 3. Wrap the gun
Wrap the gun around the mouthpiece with foil, so that it is the only hole there is (make the hole as small as possible). This will keep the gun secure and not melting.
Step 4. Load the gun
Fill the water container with lighter fluid.
Step 5. Glue the candle
Attach the candle to the end of the bracket. You can use adhesive, chewing gum, or anything other than glue.
Step 6. Light the candle
Light the candles the way you like.
Step 7. Use the gun to shoot
Don't forget to pump it first.
Tips
- Do not use glue, because once the wax has melted, you may want to replace it.
- If the flame comes out too big, slide the candle down a little.
Warning
- Use very carefully.
- You are advised to do this outside.
- If the spray tip catches fire, blow on it and extinguish it.
